Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2016 2
INSTALLATION INSTRUCTION
Aether 3.5” Shallow Recessed Housing and Trims
HR-3LED-H17A
HOUSING INSTALLATION:
1. Install housing using two hanger bars provided, align the bottom
of the hanger bar with the bottom of the joist, secure the
“screw-nail” on each end by screw-driver or by hammer
(See FIG.1 detail A).
Slide xture along hanger bar into desired location, use locking
screws to secure (See FIG.1 detail B).
For grid installation, hanger bars are supported on grids.
(See FIG.2)
2. To shorten hanger bars to t in a 12” joist, snap o one section of
the hanger bars (See FIG.3).
3. Remove spring latched junction box cover and connect xture
wires to building wires: insert each supply wire into appropriate
junction box connector. Connect black xture wire to hot, white
xture wire to neutral , green xture wire to ground, grey xture
wire to Dim (-) and purple xture wire to Dim (+) (See FIG.4).
To utilize ELV, wire black (line hot) and white (line neutral) in
accordance to dimmer specications. To utilize 0-10V dimming,
wire purple (dim+), gray (dim-), black (line hot), and white
(line neutral) in accordance to dimmer specications.
When not using a dimmer, connect black xture wire to hot, white
xture wire to neutral and green xture wire to ground. Leave all
other wires capped individually. Place all wiring and connectors
back in junction box and replace the junction box’s cover.
Place all wiring and connectors back in junction box and replace
the junction box’s cover.
FIG.1
FIG.2
FIG.3
FIG.4
A
A
B
B
Snap o one section t in a 12” joist
Green: ground
Black: hot
White: neutral
Grey : 0 - 10V Dim (-)
Purple : 0-10V Dim (+)