Installation Sheet

3WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2016
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
FIG. 9
BLACK
GREEN
WHITE
+DIM: PURPLE
-DIM: GREY
5. Remove xture junction box door and connect xture wires
to building wires: insert each supply wire into appropriate
junction box connector. This xture features electronic low
voltage (ELV) or 0-10V dimming capabilities (See FIG 9).
To utilize ELV, wire black (line hot), white (line neutral) and
green (ground) in accordance to dimmer specications.
To utilize 0-10V dimming, wire purple (dim+), gray (dim-),
black (line hot), white (line neutral) and green (ground) in
accordance to dimmer specications.
When not using a dimmer, connect black xture wire to hot,
white xture wire to neutral and green xture wire to ground.
Leave all other wires capped individually.
Place all wiring and connectors back in junction box and
replace the junction box’s cover.
6. Unlock the locking bars and adjust the angle of the trim
mounting plate. Relock the locking bars once the mounting
plate is in the desired position (See FIG.10)
7. Cut a 5 1⁄8” x 5 1⁄8” square cutout in the ceiling at the point
of installation and install ceiling (See FIG. 11).
Note: Ceiling thickness table below:
Black:
Green:
White:
Purple:
Grey:
Line Hot
Ground
Line Neutral
0-10V Dim+
0-10V Dim-
FIG. 11
5 8”
INSTALLATION INSTRUCTION
Volta 4.5” LED - Recessed Housing
R4S Series (Trim)
FIG. 10
Unlock and adjust angle for trim mounting plate