Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
H / L / J Track Wall Mount Suspension Bracket
TBKT
SAFETY INSTRUCTIONS:
1. Read all of these instructions before installing the track system.
2. Turn o power at main switch before installing or modifying the system.
3. Do not install within six inches of any curtain or combustible materials.
4. Do not install less than 5 feet above a oor.
5. Do not install in damp or wet locations.
6. Do not connect a track to more than one branch circuit.
7. Do not exceed 15lbs maximum weight for every 4 feet track length.
8. All installation shall be in accordance with NEC and all local codes.
MOUNTING STEPS
The track bracket extends 24 inches from the wall, for use with all line voltage
tracks of WAC. Powered through a live end connector. Use a minimum of two
brackets for 2 or 4 feet track, and three for 6 or 8 feet track.
1. Make sure power is o.
2. Hold the track bracket to the wall and mark the position of mounting
holes. Space between brackets should align with pre-drilled
holes on the track.
3. Secure the plastic wall anchor into the marked location of the wall.
4. Hold the track bracket vertically and secure on wall with screws provided.
5. Raise the track to brackets and secure track to bracket with
toggle bolts provided.
6. If additional holes in track are needed, drill 3/16 inch holes through the
centerline of track ( Additional holes must be at least 6 inches
from end of track.).
7. Fully tighten toggle bolts after all electrical connections are made.