Installation & Assembly

INSTALLATION INSTRUCTION

LED DISC

FM-304

WARNING

IMPORTANT: NEVER attempt any work without shutting oﬀ the electricity.

- Read all instructions before installing.

- System is intended for installation by a qualiﬁed electrician in accordance with the National Electrical Code and local regulations.

- Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or

switch ”OFF” the circuit breaker switch(es) that control the power to the ﬁxture or room that you are working on.

- Place the wall switch in the “OFF” position.

- Supply conductors (Power Wires) Connecting the ﬁxture must be rated minimum 90°C. If uncertain, consult an electrician.

CAUTIONS

- These luminaires (ﬁxtures) are designed to meet the latest NEC requirements.

- Before attempting installation, check your local electrical code, as it sets the wiring standards for your locality.

Fig. 1

1. Twist lens cover counter-clockwise to remove from Disk Light.

2. Install cross bar to the 4” junction box with junction box screw.

ELECTRICAL CONNECTION

3. Provide electrical service according to the “National Electrical

Code” or your local electrical code to the outlet box.

4. Connect supply wires to ﬁxture wires and insulate with proper

size wire nuts (Fig 1).

a) Connect incoming ground wire (green or bare) to ﬁxture

ground wire (green or bare).

b) Connect incoming common (white) wire to ﬁxture common

(white).

c) Connect incoming hot (typically black) wire to ﬁxture

black wire.

5. Attach the ﬁxture to the cross bar and outlet box by fastening

supplied 1½” outlet box screws through canopy keyholes. Make

sure Disk Light is ﬂush to the ceiling. (Fig. 1)

6. Twist the lens clockwise on disc light metal enclosure and lock

the lens in place.

Outlet Box (not included)

Mounted Screw

Cross bar needed only

for 4” junction box

Keyholes

Disc Light

Ground

White

Black

Lens

INSTALLATION

Over standard electrical junction box

PAGE 1
INSTALLATION INSTRUCTION LED DISC FM-304 WARNING IMPORTANT: NEVER attempt any work without shutting off the electricity. Read all instructions before installing. System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations. Go to the main fuse box, or circuit breaker.
PAGE 2
INSTALLATION INSTRUCTION LED DISC FM-304 Installation onto existing 4 inch recessed housings 1. Twist lens cover counter-clockwise to remove from Disk Light. 2. Attach plastic insert to Disk Light using supplied ¼” screws. (Fig. 2) 3. Detach the orange connector from socket adapter and insert black and white fixture wire into non-wired half of orange connector following color code marked. (Fig. 3) 4. Screw the socket adapter to socket in housing. (Fig. 4) 5.