Installation Instructions

INSTRUCTIONS: Framing Projector

Model: J-LED009&H-LED009&L-LED009

 CAUTION: Always turn off power at main switch prior to installation to prevent electrical shock.

1/2

Overview:

The J-LED009 framing projector creates a square or rectangular area of light to frame or highlight

artwork. By using two lenses, the fixture controls the size and sharpness of the edge of the light beam.

The fixture may also be used to project images on a wall through the use of a flat disc or lens called a

gobo.

For optimum performance highlighted objects should be 3 to 5 times the light level of ambient room light.

Installing to Track:

1. Note the track has a groove

running it’s length to indicate

polarity.

2. Note the arrow direction on the top

of the ballast case and the contact

marked with a letter “P”.

3. Insert adapter into track slot and

rotate it 90 The “P” contact

installs to the grooved side of the

track.

4. Push and turn the locking tab in

the same direction until seats in

the track.

Removal is the reverse procedure. Track

heads may be positioned anywhere along

the track len

th.

Driver case

Locking tab

Decorative knob

Shim (one of four)

Lens adjustment

(one on either side)

Front barrel

Lens mask

Rear barrel

Rear cap

PAGE 1
INSTRUCTIONS: Model:  Framing Projector J-LED009&H-LED009&L-LED009 CAUTION: Always turn off power at main switch prior to installation to prevent electrical shock. Overview: The J-LED009 framing projector creates a square or rectangular area of light to frame or highlight artwork. By using two lenses, the fixture controls the size and sharpness of the edge of the light beam. The fixture may also be used to project images on a wall through the use of a flat disc or lens called a gobo.
PAGE 2
Adjustment: 1. Four metal shims are held in place between two spring plates, move the shims to define the light area. Spring tension will hold the shims where they are set. 2. Once the shims are in place the size can be further adjusted by varying the position of the lenses. There are two lens adjustment knobs located on either side of the front barrel. Slide the lenses until the size is right and the edge is sharp. Secure the setting by tightening the adjusting knobs. 3.