Installation & Assembly

ManualsBrandsWAC Lighting ManualsCeiling LightsGenesis 1 - Light Single Globe Pendant

1 / 2

INSTRUCTIONS: LED Pendant

Model: LED311, LED314, LED315

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY.

Save these instructions.

Overview:

Pendant sockets sets are designed for use with all WAC quick connect adapters. They may also be used on

other manufacturers brand of quick connect (consult factory for compatibility). Pendants may be mounted to

mono rail, monopoints, or line volt track, by coupling to a low voltage quick connect adapter. Sockets are

supplied with a 6′cable and may be field cut to desired length.

Installing Pendant to Quick Connect:

1. Insert the post of the quick connect into the

quick connect adapter.

2. Thread the top half of the conical section until

it seats with the adapter.

3. Adjust fixture position, use caution not to

loosen the conical section.

See reverse for field shortening pendants.

Installing to Quick Connect

Quick connect adapter

Top Conical section

LED311 LED314 LED314 LED315

Summary of content (6 pages)

PAGE 1
INSTRUCTIONS: Model: LED Pendant LED311, LED314, LED315 INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY. Save these instructions. LED311 LED314 LED315 Overview: Pendant sockets sets are designed for use with all WAC quick connect adapters. They may also be used on other manufacturers brand of quick connect (consult factory for compatibility). Pendants may be mounted to mono rail, monopoints, or line volt track, by coupling to a low voltage quick connect adapter.
PAGE 2
To Install/ Shorten Pendant: All Pendant shades use the quick connect adapter to attach to the rail. On the QP-601 the mating piece (top conical section) for quick connect adapter comes uninstalled. Feed the cable end through the glass shade and the metal finial. If cable needs to be shortened, make the cut now. To install the top conical section, follow the step-by-step instructions bellow.
PAGE 3
INSTRUCTIONS: Quick Connect Canopies Models: QMP-G1RN CAUTION: Read all instructions. Do not conceal or extend exposed conductors through a building wall. Do not install this system in wet locations. For low voltage exposed insulated conductor systems required by 30.1© do not install any part of this system less than 7 feet (2.2m) above the floor. To reduce the risk of fire and burns, do not install this lighting system where the exposed bare conductors can be shorted or contact any conductive materials.
PAGE 4
INSTRUCTIONS: Models: Quick Connect Canopies QMP-G3RN CAUTION: Always turn off power at fuse box prior to installation to prevent electrical shock. For installation by a qualified electrician. Line voltage wire must be 12AWG BX or Romex wire. Install over a standard 4 inch junction box. All wires must be contained in the junction box. Overview: Canopies are designed to fit all W.A.C quick connect fixtures.
PAGE 5
Instruction：： Model：： Quick Connect Canopies QMP-G6RN CAUTION: Always turn off power at fuse box prior to installation to prevent electrical shock. For installation by a qualified electrician. Line voltage wire must be 12AWG BX or Romex wire. Install over a standard 4 inch junction box. All wires must be contained in the junction box. Overview: Canopies are designed to fit all WAC quick connect fixtures.
PAGE 6
Instruction：： Model：： Quick Connect Canopies QMP-G12RN CAUTION: Always turn off power at fuse box prior to installation to prevent electrical shock. For installation by a qualified electrician. Line voltage wire must be 12AWG BX or Romex wire. Install over a standard 4 inch junction box. All wires must be contained in the junction box. Overview: Canopies are designed to fit all WAC quick connect fixtures.