Installation

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. FEBRUARY, 2015
INSTALLATION INSTRUCTION
Tesla LED Multiple Spots Energy Star®
MT-5LD125H-NA, MT-5LD225H-NA, MT-5LD325H-NA, MT-5LD425H-NA, MT-5LD445H-NA
WARNING
IMPORTANT: NEVER attempt any work without shutting o the electricity.
- Read all instructions before installing.
- System is intended for installation by a qualied electrician in accordance with the National Electrical Code and local
regulations.
- Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or
switch ”OFF” the circuit breaker switch(es) that control the power to the xture or room that you are working on.
- Place the wall switch in the “OFF” position.
CAUTION
- All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts
that are worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of this xture.
CAUTION When handling the xture, do not apply pressure to the LEDs. Hold the xture by the base only.
AVERTISSEMENT
IMPORTANT : Coupez l’électricité avant TOUTE manipulation.
- Lisez toutes les instructions avant d’installer.
- Système est destiné à être installé par un électricien qualié en conformité avec le code national de l’électricité et les
règlements locaux.
- Accédez au panneau central de disjoncteurs ou de fusibles de votre demeure et placez l’interrupteur principal en
position d’arrêt (« OFF »).
- Placez l’interrupteur mural en position d’arrêt (« OFF »).
MISE EN GARDE
- Toutes les pièces doivent être utilisées tel qu’il est indiqué dans ces instructions. Ne remplacez pas les pièces, n’en
laissez pas de côté et ne les utilisez pas si elles sont usées ou brisées. Le non-respect de ces instructions peut annuler
l’homologation ETL/CETL du luminaire. MISE EN GARDE Ors de la manipulation de l’appareil, ne pas appliquer de pression
à la LED, tenir l’appareil par la seule base.
HARDWARE
OVERVIEW
Housing is new construction NON-IC, AIRTIGHT. Housing requires a trim or invisible trim for nished look.
Check catalog for various trim or invisible trim choices.
HOUSING INSTALLATION
1. Install housing using hanger bar provided (See FIG.1), or using channel by others (See FIG.2). Adjust housing to
the proper height by loosening the screw nuts on both adjustable brackets. Tighten the screw nuts (See FIG.2)
2. Compress adjustable mounting bracket, slide housing along bar hangers or channel into desired location.(See FIG.3)
3. Junction box is suitable for branch wiring and has trade size knockouts and integral non-metallic sheathed
cable connectors.
4. Remove spring latched junction box cover (as Fig.4) and connect xture wires to building wires: insert each supply wire
into appropriate junction box connector. Connect black xture wire to hot, white xture wire to neutral and green
xture wire to ground (as Fig.5). Place all wiring and connectors back in junction box and replace the junction box’s cover.
5. When installing in drywall, cut a hole in the ceiling (see “CUTOUT”).