Installation Sheet

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Dec 2021
dweLED.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
2
INSTALLATION INSTRUCTION
812-LED Wall Sconce
WS-81208
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Wiring
PREPARATION
1. Shut off the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (B) from the xture.
4. Secure the mounting back plate to the junction box
using the screws provided with the junction box.
Note: (i) using any other non-original-manufacturer
provided junction box screw may result in safety issue;
(ii) The side of the mounting plate marked “GND”
must face out.
5. The lamp can switch between three color temperatures
(2700k-3000k-3500k),which can be adjusted to your preference
with the switch in the lamp body (Fig.3). Set to desired
color temperature.
CONNECTING THE WIRES (Fig. 2)
6. Connect the input wires to junction box wires
as shown (Fig. 2). Make sure that all wire connectors (A) are
secure. If your outlet box has a green or bare copper
ground wire, connect the xture’s ground wire to it. Otherwise,
connect the xture’s ground wire directly to the back plate using
the GND screw provided. After wires are connected, tuck them
carefully inside the junction box.
COMPLETING THE INSTALLATION
7. Secure the xture to the mounting back plate using
the mounting screw (B) .
Wire Connector
Junction Box Screw
Mounting Screw
Mounting Back Plate
Junction Box
B
A
Silicone Gasket
C
3CCT Switch
Fig. 3
Fig. 1
Mounting Plate
Junction Box Screw
Junction Box
Mounting Screw
Wire Connector
Ground Wire
Plate Glass
B
Lamp Body
A
3000K3500K 2700K
Mounting Plate Dimensions
4"
1 3/8"
1 3/4"
6"
滚滚长江东逝水
Fig. 2