Installation Guide

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY 2020
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
2
INSTALLATION INSTRUCTION
1901- Vega Wall Sconce
WS-W1901
09/WS-W190114
Fig.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
F
ig.3 Wiring
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (B) from the fixture.
4. Secure the mounting back plate to the junction box using the screws (D) provided.
NOT
E: The side of the mounting plate marked “GND” must face out.
5. For WS-190114, further secure your mounting back plate to the mounting surface using the wood
screws (E) and Plastic Anchors (F) provided at the additional keyholes in the mounting plate (Fig. 2).
CONNECTING THE WIRES (Fig. 2)
5. Connect the fixture’s input wires to junction box wires as shown (Fig. 3). Make sure that all wire connectors (A) are secure. If your outlet box
has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
COMPLETING THE INSTALLATION
6. Secure the fixture to the mounting back plate using the mounting screw (B) and Rubber gasket(C).
7. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of fixture (Fig.4)
Mounting Hole Dimensions
G
N
D
1
3
4
"
1
3
8
"
Ground Wire
Junction Box Screw
A
Wire Connector
Fixture
Junction Box
Mounting Back Plate
Caulking
Junction Box
Fig.4
B Mounting Screw
C Rubber Gasket
D
Fig.2 (WS-190114 only)