Installation Sheet

2
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
INSTALLATION INSTRUCTION
918 – LED Outdoor
WS-W91809 / WS-W91816 / WS-W91824
PREPARATION
1. Shut o the power at the circuit breaker and remove existing
xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a
clear area. Be careful not to lose any small parts necessary for
installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (C) and silicon gasket (D) from
the mounting back plate.
4. Secure the mounting back plate to the junction box using
junction box screws (B). The side of the mounting back plate
marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
5. Connect the xture’s wires to junction box wires as shown in
Fig. 2, making sure that all wire connectors (A) are secured.
If your outlet box has a green or bare copper ground wire,
connect the xture’s ground wire to it. Otherwise, connect the
xture’s ground wire directly to the back plate using the green
screw provided. After wires are connected, tuck them carefully
inside the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
6. Secure the xture to the mounting back plate using the mounting screw (C) and the silicon gasket (D).
7. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape Fig.3.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
G0
Mounting Backplate
Junction Box
Caulking
Fig. 3
Fig. 1
C
D
A
B
Mounting Screw
Silicon Gasket
Junction Box
Ground Wire
Wire Connector
Mounting Backplate
Junction Box Screw
Fixture
WS-W91809-4 1/8”
WS-W91816-5 5/8”
WS-W91824-7 5/8”
1 3/8”
4 1/8”
1 3/4”