Installation & Assembly

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Dec 2017
2
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
ROUND
FM-07RN, FM-11RN, FM-15RN
Fig. 3
1.
2.
Provide electrical service according to the “National Electrical
Code” or your local electrical code to the outlet box.
3.
Connect supply wires to input wires on the mounting
plate and insulate with proper wire nuts:
Connect incoming ground wire to mounting plate ground wire
(green or bare).
Connect incoming common wire to xture common (white).
Connect incoming hot wire to xture black wire.
4.
3", 4" or 3/0-4/0 electrical
box, (by others)
Fixture
INSTALLATION FOR FM-15RN
Uses 3” junction box, 4" junction box or a combination
3/0-4/0 electrical box.
Wire Connector
Remove the mounting plate from the rest of the fixture
by rotating it counter clockwise. Disconnect the quick
connect cable between the mounting plate and the
fixture.
Install the provided mounting plate to the junction
box using the junction box screws provided.
Note: To guarantee a secure installation of the
mounting plate, please fasten additional screws (that
are appropriate for your mounting surface) to tighten
the mounting plate directly to the mounting surface.
5.
Clip the retention cable into the retention cable slot
on the mounting plate.
6.
Reconnect the quick connect cables between the
mounting plate and fixture. Push the wires and
connector into the junction box through semi-
circle opening on the mounting plate.
7.
Raise the fixture to mounting plate and guide the
metal clips through the slots in the mounting
plate until the fixture if flush with the mounting
surface.
8.
Rotate the fixture clockwise until fully tightened
with the mounting surface.
Surface Mount Screw Holes
Mounting Plate
Clip Slot
Junction Box Mounting
Screw
Clip Slot
Metal Clip
Fig. 4