User manual

Industrial Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO: www.adfweb.com Phone [phone]
Document
code: MN67561_ENG Revision 1
.
001
Page
9
of
12
User Manual
ProfiBus Slave to
Serial Communication
Master
UPDATE DEVICE:
Section “Update device” (Fig. 6):
In order to load the parameters or update the firmware in the
gateway, follow these instructions:
 Turn off the Device.
 Connect the Null Modem Cable Form your PC to the
Gateway.
 Insert the Boot Jumper (see the Fig. 1 for more info).
 Select COM port and press the “Connect” Button.
 Turn on the device.
 Check The BOOT Led. It must to Blink quickly (see the
Fig. 1 for more info).
 Press the “Next” Button
 Select which operations you want to do. Can select only
Firmware or only Project or both.
 Press the “Execute update firmware” to start the upload.
 When all the operation are “OK” turn off the device.
 Disconnect the Boot jumper.
 Disconnect the RS232 Cable.
 Turn on the Device.
At this point the configuration/firmware on the device is
correctly update.
Figure 6: Update Device Serial