Programming module and software for Wachendorff panel meters and controller TA/TH/TI/UA/UR/VZ/ZD Installation manual Version 2.0 July 2013 Copyright by Wachendorff Prozesstechnik GmbH & Co. KG, Industriestraße 7, D-65366 Geisenheim, Tel.: +49-6722/9965-20, Fax: -78. Information without warranty, errors and changes reserved.
Programming kit SFUR0KIT 1. Introduction Dear valued Customer! Thank you for purchasing and using a product from our company. The Programming kit SFUR0KIT from Wachendorff Prozesstechnik GmbH Co.KG can be used for the programming of Wachendorff panel meters and controllers.
Programming kit SFUR0KIT 3. Description “Wachendorff Anzeigen-Regler“ is a dedicated software package for the configuration of Wachendorff panel meters and controller. It comes together with mini-USB cable and Programming module as part of the programming kit.
Programming kit SFUR0KIT 4. How to start Once the software and drivers have been successfully installed, the system is ready to use. The following paragraph will suggest some basic steps in order to get acquainted with the application and verify the correct operation of all parts. Connect the Programming module to an USB port of your PC by means of the cable supplied with the kit. A) If drivers have been installed correctly, after a few seconds the system will confirm the new hardware as shown in Figure 2.
Programming kit SFUR0KIT Figure 5: Communication is managed by the user, selecting the options in the relevant fields. D) Select the relevant model in the“Device” field Figure 6: Field for the selection of device E) Reading of the parameter To start reading the parameters, press button „Read“ as shown in Figure 7.
Programming kit SFUR0KIT Figure 7: : Automatic search If communication panel visualizes the writing “Successful read” as shown in Figure 9, it means that communication works properly and the system has been set correctly. Otherwise it will be necessary to check each previous step. Figure 8: Reading completed successfully 5. Overview Menu and toolbar (Figure 4 and Figure 5) have already been introduced in the previous chapter about automatic communication mode.
Programming kit SFUR0KIT Figure 10: the buttons on toolbar enable to zoom in and enlarge a specific area of diagram , to show its precise value at a certain point , to print , save as bitmap file or all stored values. text file The contents of Parameters and Set point areas varies according to the selected device. Values might be those previously stored on a configuration file or they might be default values for each field anytime you select a new device.
Programming kit SFUR0KIT 8. Other regulations and standards WEEE Informationen Disposal of old electrical and electronic equipment (as in the European Union and other European countries with separate collection systems).This symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead, it should be taken to an applicable collection point for the recycling of electrical and electronic equipment.