User manual
62 UA964801 - User manual User manual - UA964801 63
7.2 Display
It visualizes the process, the setpoints and all conguration parameters. The
programming/ operation interface with text menus in 5 languages makes the
navigation intuitive.
This page displays the process, the relays
status and the serial communication (if
available).
This page displays the process, the relays
status and a graph representing the process
trend.
This page displays the process and its
graphic representation as bargraph.
8 Controller Functions
8.1 Memory Card (optional)
Parameters and setpoint values can be duplicated from one controller to another
using the Memory card.
2 modes are available:
1.
With the controller connected to the power supply:
:
Insert memory card when the controller is o. On activation the LCD visualizes
Load data
and
Esc
in correspondence of the relative keys (only if the correct
values are saved in the memory card. If not, you must update the memory card).
Pressing
Load data
the controller loads the new values. Pressing
Esc
the device
keeps the old values.
2.
With the controller not connected to the power supply:
The memory card is equipped with an internal battery with an autonomy of about
1000 uses (2032 button battery, replaceable).
Insert the memory card and press the programming button. When writing the
parameters, led turns red and on completing the procedure it changes to green. It
is possible to repeat the procedure without any particular attention.
NB
: it is not possible to transfer the parameters of a device to one with dierent
code: the LED lights red.
Updating Memory Card
.
To update the memory card values, follow the procedure described on
rst mode, pressing
Esc
so as not to load the parameters on controller.
Enter conguration and change at least one parameter. Exit conguration.
Changes are stored automatically.