User manual
UR3274U - User manual 17
output percentage command unchanged as generated
by the PID immediately before breakage.
. Pre-Programmed Cycle
Pre-programmed cycle function activates by setting
p r. cY.
on
parameter 48
o p.Mo.
Controller reaches setpoint1 basing on the gradient set on pa-
rameter 51
Grad .
, then it reaches max. power up to setpoint2.
When the process reaches max. power, this setpoint is main-
tained for the time set on parameter 52
m a . t.i .
At expiry, process will reach ambient temperature according
to gradient entered on parameter 64
f a .G r.
, then command
output will be disabled and display will visualize
Sto p
.
Setpoint
Time
Setpoint 1
Setpoint 2
Maintenance time
Cooling
Max Power
Rising gradient
Cycle starts at each activation of the controller, or via digital
input if it is enabled for this type of functioning (see parame-
ter 50
d Gt.i .
).
. Programming module
Parameters and setpoint values can be duplicated from one
controller to another using the Programming module.
There are two methods:
• Withthecontrollerconnectedtothepowersupply