User manual

UR3274U - User manual 19
Press Eect Do

FNC
for  sec.
Display  shows 0000
with the st digit
ashing, while display
 shows
pass

or
Change the ashing
digit and move to the
next one using the
SET
key.
Enter password 9999

SET
to conrm
Instrument loads
default settings
Turn o and restart
the instrument
. LATCH ON Functions
For use with input P o t .1 (potentiometer 6K) and Po t.2 (po-
tentiometer 150K) and with linear input (0…10V, 0...40mV,
0/4…20mA), it is possible to associate start value of the scale
(parameter 6
Lo .L.i . ) to the minimum position of the sensor
and value of the scale end (parameter 7
u p. L.i . ) to the maxi-
mum position of the sensor (parameter 8
La t c. congured as
std. ).
It is also possible to x the point in which the controller will
display 0 (however keeping the scale range between
Lo .L.i .
and
u p. L.i . ) using the “virtual zero” option by setting u.0st.
or
u.0in. in parameter 8 La t c. If you set u.0in. the virtual zero
will reset after each activation of the tool; if you set
u.0st. the
virtual zero remains xed once tuned.
To use the LATCH ON function, congure according to requi-
red operation the parameter
La t c.


The tuning procedure starts by exiting the conguration after changing