User manual

UR3274U - User manual 25
. Single Timer
This option enables one single Timer and the time is selecta-
ble by the operator.
To achieve this operation set parameter 63
t m r. f. as follows:
• s.tm.s. (Single Timer Seconds) time-basis in seconds (mm.ss)
•
s.tm.m. (Single Timer Minutes) time-basis in minutes (hh.mm)
To start/stop the Timer, press
FNC
for 1 “.
During the counting, Led
R
is On and display2 shows decre-
menting time. At elapsing of Timer, led
R
switches o and
display 2 ashes, visualising the programmed time until any
key is pressed.
Start/Stop of Timer is possibile also by digital input, selecting
t.1.s.s. on parameter 50 d Gt.i .
. Dual Timer
This option enables two Timers and the time is selectable by
the operator: timers cannot be started at same time.
To achieve this operation set parameter 63 as follows:
• d.tm.s. (Double Timer Seconds) time-basis in seconds (mm.ss)
• d.tm.m. (Double Timer Minutes) time-basis in minutes (hh.mm)
Check the table below for the Start procedure:
Press Eect Do

FNC
Press until ti m . 1 or ti m .
2 visualized on display .

Start the Timer. Display 
shows decrementing time
and Led
R
switches on
(xed for timer , ashing
for timer ).
Back to point , after
selection of running Timer
press
to stop counting.
Led
R
switches o.
At elapsing of Timer the led
R
switches o and display