User manual

40 UR3274U - User manual
 o . c a L. Oset Calibration
number added to process value visualized on display
(usually correcting the ambient temperature value).
-…+ [digit

] for linear sensors and potentiometers.
-.…+. (degrees.tenths for temperature sensors). >
Default: 0.0.
 G. c a L. Gain Calibration
this % is multiplied with displayed value to calibrate the
process value. -.%…+.% > Default: 0.0

act.t. Action type
regulation type
heat Heating (N.A.) > Default
co o L, Cooling (N.C.)
H.o.o.s. If process is above setpoint, output is disabled
(Heating).

c. re. Command Reset
type of reset for state of command contact (always
automatic in PID functioning).
a. re. Automatic Reset > Default
m. re. Manual Reset
m. re.s . Manual Reset Stored

c. s. e. Command State Error
state of contact for command output in case of error.
c. o . > Default
c. c.
 c. Ld. Command Led
state of OUT1 led corresponding to the relevant contact.
c. o .
c. c. > Default