User manual

UR3274U - User manual 49
rn.n.c. Run n.c.
L.c.n.o. Lock Conversion n.o. (Lock visualisation on display
with N.O. contact)
L.c.n.c. Lock Conversion n.c. (Lock visualisation on display
with N.C. contact)
tune Tune > Manual
a.ma.i. Automatic Manual impulse
a.ma.c. Automatic Manual Contact
t.1.s.s. Timer 1 Start Stop

Grad . Gradient
Rising gradient for soft start or pre-programmed cycle
 Disabled > Default: 0.
- Digit/time

(degrees/hours with display of tenths if
temperature)

m a . ti . Maintenance Time
maintenance time for pre-programmed cycle
.-. hh.mm > Default: 00.00

u.m.c.p. User Menu Cycle Programmed
Allows the rising/falling gradient and the maintenance time
to be changed from the user menu in pre-programmed
cycle functioning.
di s . Disabled > Default
ri . G r . Rising Gradient (modify gradient)
m a . t.i . Maintenance Time (modify time)
r.G.m.t. Rising Gradient and Maintenance Time (modify both)
f a .G r. Falling Gradient (modify cooling gradient)
r. f.G r. Rising and Falling Gradient (modify rising and
cooling gradient)
f.G.m.t. Falling Gradient and Maintenance Time

The display of decimal point depends on the setting of parameter sen.
and the parameter d. p.