User manual

UR3274U - User manual 57
E-0 6
s e r. e .
O-line in master mode
remote process
Check the serial
connection, baud-rate
and device ID.
E-0 8
sYs. e.
Missing calibration data Call Assistance
 Summary of Conguration parameters
Date: Model URU:
Installer: System:
Notes:
c.out
Command output type selection
sen.
Analog input conguration
d. p.
Number of decimal points
Lo .L. s .
Lower limit setpoint
u p.L.s .
Upper limit setpoint
Lo .L.i .
Lower limit range An only for linear
u p. L.i .
Upper limit range An only for linear
La t c.
Automatic setting of linear input limits.
o.caL
Oset calibration
G. caL
Gain calibration
act.t.
Regulation type
c. re.
Command output reset type
c. s. e.
Contact state for command output in case
of error
c. Ld.
Dene the OUT led state
c. HY.
Hysteresis in ON/OFF or dead band in P.I.D.
c. d e.
Command delay
c. s. p.
Command setpoint protection
p. b.
Proportional band
t.i .
Integral time
t.d.
Derivative time