User manual

56 - UR4848 - User manual UR4848 - User manual - 57
A.1.HY
Alarm 1 hysteresis
a.1.de.
Alarm 1 delay
a.1.s.p.
Alarm 1 set protection
aL. 2
Alarm 2 selection
a.2.s.o.
Alarm 2 output contact and intervention type
a.2.re
Reset type of alarm 2 contact
a.2.s.e.
State of contact for alarm 2 output
a.2.Ld.
State of OUT2 led
A.2.HY.
Alarm 2 hysteresis
a.2.de.
Alarm 2 delay
a.2.s.p.
Alarm 2 set protection alarm 2 set protection
aL. 3
Alarm 3 selection
a.3.s.o.
Alarm 3 output contact and intervention type
a.3.re.
Reset type of alarm 3 contact
A.3.S.E.
State of contact for alarm 3 output
a.3.Ld.
State of OUT3 led
a.3.HY.
Alarm 3 hysteresis
a.3.de.
Alarm 3 delay
a.3.s.p.
Alarm 3 set protection
t.a.
Activation and scale range of Current transformer
L.b.a.t.
Intervention threshold of Loop Break Alarm
L.b.a.d.
Delay time for Loop Break Alarm intervention
coo.f.
Cooling uid type
p.b.m.
Proportional band multiplier
ou.d.b.
Overlapping / Dead band
co.t.c.
Cycle time for cooling output
c.fLt.
Analog converter lter
c.Frn.
Sampling frequency of analog converter
u.fLt.
Display lter
tune
Autotuning type selection
s.d.tu.
Command setpoint deviation for tuning threshold
op.mo
Operating mode
au.ma.
Automatic / manual selection
dGt.i.
Digital input functioning
Grad.
Gradient for Soft-Start
ma.ti.
Cycle maintenance time
u.m.c.p.
Gradient change and maintenance time by user
ui.tY.
Display data selection
deGr.
Degree type selection
retr.
Retransmission for output 0-10 V or 4…20 mA
LoL.r.
Lower limit range for linear output
up.L.r.
Upper limit range for linear output
bd.rt.
Select baud rate for serial communication
sL.ad.
Select slave address
se.de.
Select the serial delay
L.L.o.p.
Lower limit of heating output percentage
Notes / Updates