User manual

URDR0001 - User manual - 21
7.8 Programming Module (optional)
Parameters and setpoint values can be duplicated from one controller to another
using the Programming Module.
2 modes are available:
• Withthecontrollerconnectedtothepowersupply.
Insert memory card when the controller is o.
On activation display 1 shows
memo and display 2 shows --- (only if the correct
values are saved in the Programming Module). By pressing
key display 2
shows
Lo a d , then conrm using
SET
key.
Controller loads the new value and restarts.
RED LIGHT: waiting for programming
GREEN LIGHT: done