User manual

40 - URDR0001 - User manual
13 c. S. e. Command State Error
State of contact for command output in case of error
c. o . Open contact (Default)
c. c. Closed contact
14 c. Ld . Command Led
State of the OUT1 led corresponding to the relevant contact
c. o . ON with open contact
c. c. ON with closed contact (Default)
15 c. HY. Command Hysteresis
Hysteresis in ON/OFF or dead band in P.I.D.
-999…+999 [digit3] (degrees.tenths for temperature sensors), De-
fault
0.0.
16 c. d e. Command Delay
Command delay (only in ON / OFF functioning). In case of servo val-
ve it also works in P.I.D. and represents the delay between opening
and closure of the two contacts
-180…+180 seconds (tenths of second in case of servo valve).
Negative: delay in switching o phase.
Positive: delay in activation phase. Default: 0.
17 c. s . p. Command Setpoint Protection
Allows or not to modify the command setpoint value
free Modication allowed (Default)
Lo ck Protected