Product Manual

9 Operation and use
100_0202_op_0009.fm 29
9.3.3 Commissioning the machine (electric start)
1. Put the throttle lever in the full throttle position.
2. Insert the ignition switch key into the ignition lock and turn to the right. The charge control lamp will
illuminate and the acoustic signal will sound.
3. Turn ignition switch key to position ll. As soon as the engine starts, release the ignition switch key.
4. Put the throttle lever in the idling position.
5. Allow the machine to warm up by idling for a few minutes.
9.3.4 Commissioning the machine (Recoil starter)
1. Turn the fuel cock to ON.
2. Put the throttle lever in the idling position.
3. Turn the ignition key switch to l.
4. Pull out the starter rope slowly up to the compression resistor.
5. Press and release the decompression lever.
6. Quickly and strongly pull the starter rope on the starter handle while pulling the rope as far as
possible.
7. Allow the machine to warm up by idling for a few minutes.
Item Designation Item Designation
1 Throttle lever 3 Ignition lock
2 Decompression lever 4 Charge control lamp
NOTICE
In extreme cold, actuate the decompression lever as well and push it up. In this position,
the decompression automation system audibly locks into place and the engine is ready to
start.
NOTICE
As soon as the engine starts, the vibration will begin.
CAUTION
Do not allow the starter rope to snap back against the engine. Slowly guide back by hand
to prevent damage to the starter.