Product Manual

9 Operation and use

30 100_0202_op_0009.fm

9.3.5 Machine with Compatec – compaction display (optional)

1. During the first few seconds after starting the machine, a light progress bar appears on the display

unit.

2. LEDs light up starting from left to right.

3. All LEDs will briefly light up again at reduced brightness.

4. The sensor is thus successfully tested and the display is ready for operation.

9.4 Operation

 In accordance with the intended purpose, the operator should stand behind the machine.

 Guide and steer machine using the control handle.

9.4.1 Select the travel direction

1. Put the throttle lever in the full throttle position.

2. Select travel direction and speed with the control handle.

Item Designation Item Designation

1 Display unit 2 LEDs/light progress bar

NOTICE

If all LEDs light up, the system is fault-free. The LEDs will then switch off one after the

other.

NOTICE

If all LEDs permanently light after initialization, the sensor has not been successfully

tested; see troubleshooting chapter.

Item Designation Item Designation

1Forward 2Reverse