Product Manual

10 Maintenance
38 100_0202_mt_0008.fm
Replacing the V-belt (machines with Yanmar engine)
1. Disassemble the belt guard.
2. In the event of visible damage, the V-belt must be replaced.
3. Loosen screws on the engine V-belt pulley
4. Remove external half of V-belt pulley.
5. Remove the required number of shims (removing one shim is usually enough).
 Mount the removed shims to the outside of the v-belt pulley half.
6. Place elastic shim in such a way that the large flange is seated on the V-belt pulley.
7. Screw on nuts and tighten alternately while constantly rotating the V-belt pulley.
8. Assemble the belt guard.
Replace the exciter oil and check the oil level
1. Tip the machine to the side of the filler boring and support it.
2. Place an appropriate collecting container below the filler boring.
3. Remove dirt accumulation within the range of the filler boring.
DANGER
Risk of scalding
 Use caution when draining hot oil.
NOTICE
Perform oil change and oil level check with warm exciter oil. Machine must not be in use
and must be level.
Item Designation Item Designation
1 Screw plug 2 Filler boring
NOTICE
Lay an impermeable film on the working surface to protect against escaping oil.
1, 2