Operator`s manual

Description
T01134GB.fm 31
The revs on the engine can be infinitely varied using the throttle control
lever (4); the optimum cutting speed of the blade is only achieved with
the engine working at full load.
In order to facilitate the starting, the eingine is provieded with a choke.
1.4 General instructions for use for diamond-edged cutting blades
∗ Never use a cutting blade with a larger diameter than necessary in order
to cut a certain depth.
∗ If the cutting blade comes to a standstill, remove it from the cut before star-
ting the machine again. If the cutting blade comes to a standstill in the cut,
check whether the belt is tightened adequately. Check the tension screw
and make sure that it is tightened properly.
∗ Cut in a straight line. Mark the cutting line clearly in such a way that the
operational personnel can follow it easily. This is to ensure that the floor
saw machine does not need to be redirected from one side to the other
(avoid cutting tight curves).
∗ Sufficient drive power is essential! When cutting, work at full throttle.
∗ Caution on steep tracks and levels! The machine must not exert lateral
force against the blade.
∗ Never exceed the maximum speeds (imprinted on cutting blade)!
∗ Use a suitable diamond-edged cutting blade for the material to be cut (as-
phalt, concrete ...). Wacker Neuson offers an extensive range of diamond-
edged cutting blades in different qualities.
∗ Do not cut into the gravel area using diamond-edged cutting blades. When
cutting on the edge of the track or when cutting two different materials (cut-
ting in the joint area), uneven wear is possible. Check carefully for irregu-
larities (reinforcements etc.) in the material to be processed. These can
overload the cutting blade very quickly. When starting cutting operations,
work carefully and with a low down speed.
∗ Do not process loose materials (e. g. paving stones).