Operator`s manual

Transport to the worksite
T01135GB.fm 32
2. Transport to the worksite
Requirements:
∗ When transporting the floor saw, use only suitable hoisting gear with a
minimum load-bearing capacity of 200 kg.
∗ Always turn off the motor during transportation!
∗ Empty the water tank!
∗ Remove the cutting blade prior to transport. Set the lowest cutting po-
sition on the floor saw.
∗ Attach appropriate secure lifting devices to the central lifting point (10)
provided for this purpose.
∗ If you transport the floor saw on the cargo area of a vehicle, strap it
down securely on the special safety bar.
∗ Fold the guide wheel to the top and the handles to the front (or the stir-
rup handle to the top).
∗ Apply the parking brake.
∗ Handles, guide wheel and other operating controls must not be used
as attachment points.
Note: Also observe the regulations in the chapter Safety information.