Operator`s manual

Operation
T01136GB.fm 34
3.2.2 Aligning the guide wheel
To do this, make a cut of approx. 2 m length on a flat surface and with
the minimum cutting depth. Then pull back the machine without lateral
force. Then you can align the guide wheel exactly with the cut.
3.3 Cutting depth setting
Place the quick-lift lever in the forward lock-in position; this will enable
you to exactly adjust the cutting depth by turning the crank (5). One
turn of the crank drops the cutting disc by 5 mm (cutting depth).
It is possible to choose between two lock-in positions of the quick-lift-
lever (3) at any time:
1. The forward lock-in position allows cutting with an individually set
cutting depth.
2. The cutting disc is never engaged in the material when the quick-lift
lever is in the back lock-in position. The floor saw can now be easily
moved from one working area to the next.
3.3.1 Operation of the quick-lift lever:
1. Loosen lock with the guide handle (13) and press down T-handle.
2. Push T-handle all the way forwards or, as the case may be, back-
wards.
3. Let go of T-handle. The handle will lock automatically.
Each floor saw has been equipped with a metric and an inch scale; the
scale is matched with the respective standard cutting disc.