Operator`s manual

Maintenance
T01137GB.fm 50
4.8 Changing the belt
1. Disassemble V-belt guard (above and below) and cutting disc guard.
2. Take tension off V-belts. To do this loosen the counter nut (31), the
tensioning nut (33) as well as the fastening screws (32). Only
loosen the fastening screws so far that the V-belt’s take-up can be
moved freely without play.
3. Loosen the screws (34) at the oval flanges (on both sides) of the
cutting shaft.
4. Replace the V-belts.
5. Reassemble cutting shaft (34).
6. Adjust drive belt tension with tensioning nut.