Repair manual

6 Disassembly
55 Protective hood/V-belt pulley
5. Unscrew the screws (17) with springs (18) from the thrust collar (5).
6. Take off the entire protective hood (8) with the parts 5,6,7,11,12.
7. Unscrew the Torx screws (10) and take off the handle (9).
8. Press the stop pin (21) and the screws (20) out of the cutting attachment (19).
9. Heat the cutting attachment (19).
10. Press out the ball bearing (14) and distance bushing (4).
11. Remove the retaining clip (13), disassemble the ball bearing (14) and the second
retaining clip (13).
17,18
21
20
19
19
14
13
4 13