Repair manual

8 Assembly

74 Ignition system module/intake manifold

1. Clean the cone (x) of the crankshaft and magneto flywheel.

2. Set the magneto flywheel (19) onto the crankshaft.

3. Screw the hexagonal nut (21) with the spring washer (20) onto the crankshaft

(torque wrench setting 30 - 5 Nm).

4. Connect the ignition cable (10) and short circuit cable (1).

5. Set the setting gauge (y) between the magneto igniter (12) and magneto flywheel

(19).

6. Press firmly against the magneto igniter (12) and tighten the Torx screws (11)

evenly to 6+1Nm.

7. Insert the ground cable (4) in the plug connection of the contact spring (9).

8. Connect the short circuit cable (1) with the choke shaft (18).

9. Mount the choke shaft (18) to the carburetor (17).