User's Manual

Contents Index
Contents
Index
51
51
TESTING THE EXPRESSKEYS AND ROCKER RING
Use the following procedures to test these features.
1. With the D
IAGNOSTICS dialog box open, observe the TABLET INFO column as you test each ExpressKey or
Rocker Ring position. Be sure to select the pen display you are testing from the T
ABLET INFO column.
2. Test the ExpressKeys and Rocker Ring positions by pressing them one at a time. Each time you press a
key, position or button, its number is shown next to either the L
EFT BUTTONS or RIGHT BUTTONS category,
depending on which key or position you are testing.
3. When you are done, click the
CLOSE button to exit the dialog box.
Important: Some applications can override and control the ExpressKey or Rocker Ring functions.
Consider closing any open applications except the Wacom Control Panel when testing the
ExpressKeys or Rocker Ring. For details, see Using applications integrated for tablet control
.
TESTING A PEN
1. With the DIAGNOSTICS dialog box open, and while observing the POINTING DEVICE INFO column, bring
your pen within 5 mm (0.2 inch) of the screen. A value for P
ROXIMITY, the DEVICE NAME, DEVICE TYPE, and
a D
EVICE S/N (serial number) should be displayed. Be sure to select the pen display you are testing from
the T
ABLET INFO column.
2. Move your tool along the pen screen surface. The X and Y D
ATA values should change to reflect the tool
position.
• Press on the screen surface with the tool tip. The S
WITCHES state and PRESSURE value should
change. P
RESSURE should change from approximately 0% with no pressure applied to
approximately 100% when full pressure is applied.
• Next, press the side switch without pressing the tip to the tablet. The S
WITCHES state should
change. For the Pro Pen, do this for both positions of the switch.
• Press the eraser to the screen. The S
WITCHES state and PRESSURE value should change. PRESSURE
should change from approximately 0% with no pressure applied to approximately 100% when full
pressure is applied.
• For the optional Airbrush, move the fingerwheel forward. The W
HEEL value should decrease to a
value of approximately 0 when the fingerwheel is all the way forward. Move the fingerwheel
backward. The W
HEEL value should increase to approximately 1000 when the fingerwheel is all the
way back.
Pen
S
WITCHES states
Tip = 1
Side switch (lower position) = 2
Side switch (upper position) = 3
Eraser = 1
Airbrush
S
WITCHES states
Tip = 1
Side switch = 2
Eraser = 1