User Manual
53
IndexContents
53
53
IndexContents
53
Contents
Index
Contents
Index
TESTING THE EXPRESSKEYS
1. With the DIAGNOSTICS dialog box open, observe the TABLET INFO column as you test each ExpressKey.
Be sure to select the tablet unit you are testing from the T
ABLET INFO column.
2. Test the keys by pressing them one at a time. Each time you press a key, its number is shown next to
the L
EFT BUTTONS category.
3. When you are done, click the C
LOSE button to exit the dialog box.
Important: Some applications can override and control the ExpressKey functions. Consider closing
any open applications except the Wacom Tablet control panel when testing the ExpressKeys.
For details, see Using applications integrated for tablet control
.
TESTING A PEN
1. With the DIAGNOSTICS dialog box open, and while observing the POINTING DEVICE INFO column, bring
your pen within 10 mm (0.4 inch) of the tablet active area. A value for P
ROXIMITY, the DEVICE NAME,
D
EVICE TYPE, and a DEVICE S/N (serial number) should be displayed.
2. Move your tool along the tablet surface. The X and Y D
ATA values should change to reflect the tool
position.
3. Test your pen switches. The Status LED should brighten each time you click with the tip, press the side
switch, or press the eraser to the tablet.
• Click on the tablet surface with the tip. The S
WITCHES state and PRESSURE value should change.
P
RESSURE should change from approximately 0% with no pressure applied to approximately 100%
when full pressure is applied.
• Next, press the side switch without pressing the tip to the tablet. The S
WITCHES state should
change. For the Intuos pen, do this for both positions of the side switch.
• Press the eraser to the tablet. The S
WITCHES state and PRESSURE value should change.
P
RESSURE should change from approximately 0% with no pressure applied to approximately 100%
when full pressure is applied.
4. Slowly rotate the pen on its axis. The R
OTATION value should change as you rotate the pen.
5. When you are done, click on the C
LOSE button to exit the dialog box.
Pen
SWITCHES states
Tip = 1
Side switch (lower position) = 2
Side switch (upper position) = 3
Eraser = 1