User's Manual
Table Of Contents
- Your interactive pen display
- Installation
- Working with the interactive pen display
- Customizing
- Troubleshooting
- Appendix
- Caring for the interactive pen display
- Replacing the pen tip
- Using an alternate mount or stand
- Uninstalling the interactive pen display
- Managing preferences
- Installing multiple tablets
- Pen and digital ink capabilities in Windows
- About the Windows Tablet PC Input Panel
- Product specifications
- Product information
- Ordering parts and accessories
- Available parts and accessories
- Radio and television interference
- Precautions
- Warranty (Worldwide, Except for Europe, Africa and Middle East)
- Licence warranty conditions (Europe, Africa and Middle East)
- Glossary
68
Index
Contents
68
Index
Contents
Interactive pen display
DISPLAY
Display panel a-Si Active Matrix TFT LCD
Screen size 346.232 x 195.536 mm
Aspect ratio 16 : 09
Number of pixels 1366 x 768
Input video signal Analog: 0.7 Vp-p positive at 75 ohm
H/V Separate sync, TTL Level, Positive/Negative
H/V Composite sync, TTL Level, Positive/Negative
Digital: DVI revision 1.0
Output video signal Analog: Analog output
Video: RGB (75 ohm loading)
Digital: TTL output
Pixel rate: up to 85 MHz, Sync: Hs, Vs, Xs
Resolutions, in pixels 640 x 480 @60Hz 800 x 600 @60Hz 1024 x768 @60Hz 1280 x 720
@60Hz 1280 x 768 @60Hz 1366 x 768 @60Hz
White luminance uniformity 75% (min.)
Synchronization range 30 to 70 Hz vertical, 50 to 75 kHz horizontal
Timing modes 6 preset modes + 12 user modes
Display area 344.232 x 193.536 mm
Pixel pitch 0.252 x 0.252 mm
Viewing angles @ CR10:1
(horizontal/vertical)
90 / 65 (typ.)
Display colors 16.7 million
Contrast ratio 400:1(Max.)
Response time (response time
Tr+Tf) or display response time
(Tr+Tf)
8 ms typical (rise and fall)
Luminance (brightness) 255 cd/m2 (Min)
OSD manual control Brightness, Contrast, Pitch, Phase, Vertical Position,
Horizontal position, Language, Back Light, Menu Position, Reset,
Color temperature (9300K/6500K/5000K/User/Direct)
Plug and Play DDC2B, DDC/CI
LCD quality Each interactive pen display LCD panel is produced under very stringent
quality standards. Production techniques cannot guarantee an absolutely
perfect TFT display. Wacom does not allow any pixel to be always white or
always black. A small number of pixels (4 or less) are allowed to show a wrong
color for some parts of the color spectrum. This does not mean the display is
defective.