User's Manual

INSTALLATION
Page 12
Contents
Index
GRAPHIRE TABLET INSTALLATION
USB ports support hot-plugging so you can connect or disconnect Graphire
without turning off your computer.
If you are using an iMac, refer to the iMac Requirements section before installing
Graphire.
1. Plug the Graphire USB connector into an active USB port on your computer or
into an active USB hub.
2. If your computer is off, turn it on now. The tablet LED will light to indicate
Graphire has registered as a USB device. If the LED does not light, your USB
port may not be functioning properly; go to Having Trouble?
Graphire is working in mouse emulation mode. You should be able to use your
Graphire Pen or Cordless Mouse on the tablet to move the screen cursor.
Important: You must install the tablet software from the Graphire Tablet
CD to get full tablet functionality. Disable any virus protection programs
and close all open applications before installing the software.
3. Insert the Graphire Tablet CD into your computer.
4. Double-click on the INSTALL icon. Choose your language option, click OK, and
follow the prompts.
After restarting your computer, you will be able to use the Graphire Pen to move
the screen cursor in Pen Mode. If you had any trouble with this installation, go to
Having Trouble?
To tablet