Owner manual

Model
CG-15N
BBMB
Ball Bearing
Mast bearing
244A
Cast Aluminum
Mast Clamp
Ground Anchor
CG TOWERS
Top section with top plate, cast
aluminum mast clamp and rotor plate.
www.wadeantenna.com
Guy Station where sections join.
DELHI COMMERCIAL GUYED TOWER PRODUCTS
Twelve models are available in heights from
62 ft. (8 sections) up to 147 ft. (19 sections)
plus mast.
Towers are designed to support a net
antenna weight of up to 80 lbs. with a
horizontal wind load of up to 300 lbs. plus
rotor and 2” O.D. x 10 ft. mast.
Instructions are supplied for 30 degree
guying with ground anchors 120 degrees
apart and about ½ tower height from base.
Hard Grade ¼” O.D. guy wire is
recommended.
Ideal for supporting
Communications, Civil and
Amateur Antennas
Our new Towers have been enhanced in both
leg profile and taper facilitating an easier
installation and improved tower structure.
All tower sections are eight feet long with
twist reducing beaded-channel legs riveted
together with “X” braces. Legs and cross
braces are galvanized steel, rivets are solid
aluminum, anodized. Special nuts and bolts
are ½” O.D. and heat treated.
DMX-04T and DMX-04 sections are 19” wide
and have 16 ga. legs. DMX-05 and DMX-05S
sections are 21½” wide with 14 ga. legs.
Straight sections fit smoothly together, since
all leg bottoms are accurately swaged for a
perfect fit.
The three highest towers use tapered
sections at the base.
Special three-size guy stations are strong and
reliable. They are attached every
three sections from the base up (except
CG-19N) and at the top of the tower.
Width = 1.67 m
BASE STUBS
IN CONCRETE
76mm
CLEARANCE
152 x 152mm
WIRE MESH
NTS
DEPTH =
1.2 m
CONCRETE REQUIRED = 3.34 cu.m.