User guide

DELHI TOWERS
Golden Nugget - Tubular Towers
WADE ANTENNA’S ONGOING POLICY OF CONTINUING DEVELOPMENT MAY RESULT IN SPECIFICATION CHANGES TO ITS PRODUCTS
Features
• Precision swaged legs for perfect fit.
• “Everdur” welded for high strength.
• Sleeve bearing for masts up to 1 ½”
(3.8 cm) diameter.
• Legs and braces “Galvanized” steel.
• Rotor plate for longer rotor life.
• Each section subjected to
pressure testing to ensure all
weld points pass the minimum
strength requirements. The
result is a safe and reliable tower
- look for dimple on braces.
Load Limits
Designed to support equipment up to 3 square ft. (0.28 m
2
) projected wind
area, mounted not more than 2 sections above house bracket.
Caution:
Guy wires must be used for larger loads or greater heights
above house bracket.
Sections
GN18T 18 gauge top section 9.6” (2.90 m).
GN18S 18 gauge straight section 10’0” (3.05 m).
GN16T 16 gauge top section 9’6” (2.90 m).
GN16S 16 gauge straight section 10’0” (3.05 m).
Accessories
GNHB Universal house bracket 1” O.D. (2.54 cm) x 3’ (0.91 m) arms.
GNUHB Economical “U” house bracket.
GNBP 16 gauge base plate.
DMBS Galvanized steel drive stakes. Set of three.
1 ¼” (3.2 cm) x 3’ (0.91 m).
GN3HU 3’ hinge-up base.
CS-GN Climb Shield for GN Tower.
GS-GN Guy Station for GN Tower.
DMBS
12”
(30.48 cm)
Note:
All sections complete with necessary nuts and bolts. Top sections
include top bearing set screw and lower mast clamp assembly.
GN18S
GN16S
GN18T
GN16T
12”
(30.48 cm)
11 ¾”
(39.85 cm)
10’
(3.05 m)
9’ 6”
(2.90 m)
GNHB
GN3HU
GNUHB
GNBP
GS-GN
CS-GN
NEW
NEW
www.wadeantenna.com
MADE IN CANADA