Installation & Assembly (Queen)

5
4
21
3
WALL ANCHORING INSTRUCTIONS
INSTALLATION RECOMMENDATIONS - WOOD STUDS
Determine the position of the bed in the room.
Locate and mark the positioning
of 3 studs using a stud nder.
Put the bed back in its place. Level by adjusting
the legs PA-844 previously installed. If you install
the bed on a carpet, you must raise the bed by
an extra 3/8“ (10 mm).
Move the bed if necessary, then cut and
remove the oor trim.
Line up plywood part #87 on the wall and mark the middle of the studs on the plywood, then pre-drill
part #87 with 2 pilot holes of 1/4” (6 mm) diameter per stud, 2” (50 mm) apart vertically (6 holes in total).
DO NOT DRILL HOLES INTO THE WOOD STUDS.
87
87
2” (50 mm)
1/4”
(6 mm)
87
2” (50 mm)
1/4”
(6 mm)
PA-844
14