Installation & Assembly (Queen)

6
2” (50 mm) minimum
WALL ANCHORING INSTRUCTIONS
INSTALLATION RECOMMENDATIONS - WOOD STUDS
Put the wood screws #10 x 3 1/2” (89 mm) through the holes of part #87 and screw into the center of the studs
until the plywood is tight against the wall. USE AN ELECTRIC SCREWDRIVER WITH AN ADJUSTABLE TENSION
CLUTCH THAT HELPS PREVENT OVER-TIGHTENING AND STRIPPING.
87
Drywall
Wood stud
INSTALLATION AND APPROPRIATE HARDWARE
Using appropriate hardware, all the anchor screws of the wall bed must be rmly
secured to the wood or metal studs, the structural components, or a masonry wall.
Only wall anchor screws for wood-frame walls are provided with this bed.
NEVER USE DRYWALL ANCHOR SCREWS OR SECURE THE BED TO DRYWALL
See wall anchoring requirements and installation notes provided in the
instruction manual, according to the type of wall, and use the appropriate
anchors such as described in this manual.
NUMBER OF SCREWS NEEDED
Two (2) screws are required for each anchor point. Three (3) wall anchor points
are necessary for the proper installation of the wall bed. So you need a total
of six (6) wall anchor screws.
THE SCREWS MUST BE VERY WELL ANCHORED TO THE STRUCTURAL
COMPONENTS OF THE WALL.
IMPORTANT WARNINGS
!
15