Assembly & Installation Instructions

ManualsBrandsWade Logan ManualsLantern Outdoor Wall LightingAlanson Carbon Bronze Integrated LED Seeded Glass Outdoor Wall Lantern with Dusk to Dawn

Green Grounding

Screw (C)

Headless

screw (H)

Mounting Screw (B)

Wire Connector (E)

Lock Nut (D)

Mounting Plate (A)

Ball Nut (F)

Back Plate

Ball Nut (F)

Rubber Pad (G)

Hardware Package (included):

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before

installation, discharge yourself by touching a grounded bare metal surface to remove this

hazard. To avoid damage, do not touch the LED module.

Green Grounding Screw (C)

Outlet Box

Wire Connector (E)

Headless

Screw (H)

Mounting Plate

(A)

Lock Nut

(D)

House Grounding Wire

Fixture Grounding Wire

Fixture Wire

Glass

Glass Holder

Headless screw

Ball Nut

Mounting Screw (B)

1. Thread two headless screws (H) through the mounting plate (A),

then secure them with four lock nuts (D) ( two on each side

of the mounting plate (A) ). Adjust the length of the headless screws (H) if necessary ).

Note: Make sure that the headless screws (H) are lined up horizontally, to ensure that

the fixture will be level.

2. Attach the mounting plate (A) to the outlet box by using two mounting screws (B).

Turn off the power at fuse or circuit box

Installation Steps

Summary of content (4 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before installation, discharge yourself by touching a grounded bare metal surface to remove this hazard.
PAGE 2
3. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections (E) using the wire connectors (E): ---Connect the black wire from the fixture to the black wire from the power source. ---Connect the white wire from the fixture to the white wire from the power source. ---Attach the fixture grounding wire to the cross bar with the green grounding screw (C). Then connect it to the house grounding wire with a wire connector (E). Carefully put the wires back into the outlet box.
PAGE 3
CUSTOMIZATION OPTIONS: Shut-off Delay The Shut-off delay is the length of time the light will stay at high-level brightness after motion has ceased to be detected.This Shut-off delay can be set when operation is in 3, 6 or 0 Mode by using the “TIME” knob located on the left side of the panel at the back of the sensor lens (See Fig.2) . To increase the shut-off delay, turn the knob clockwise. To decrease shut off delay, turn the knob counterclockwise.
PAGE 4
----In 3H or 6H Mode, the light turns off completely, instead of low level brightness, after 3 minutes: Make sure the low level is not at the 0% position. -- The light blinks: 1. Make sure the light is not mounted near a barbecue, air conditioner or other heat source. 2. Adjust the sensitivity knob counterclockwise to avoid unnecessary triggering like a passing car or reflecting objects. The following parts are available for re-order if damaged or missing.