Assembly & Installation Instructions

Back Plate

Mounting Plate

(A)

Green Grounding Screw (C)

Outlet Box

Wire Connector (E)

Headless Screw (H)

Lock Nut

(D)

House Grounding Wire

Fixture Grounding Wire

Fixture Wire

Mounting Screw (B)

Green Grounding

Screw (C)

Headless screw (H) Glass Holder (I)

Ball Nut-b (J)

Mounting Screw (B)

Wire Connector (E)

Lock Nut (D)

Ball Nut (F)

Rubber Pad (G)

Hardware Package (included):

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before

installation, discharge yourself by touching a grounded bare metal surface to remove this

hazard. To avoid damage, do not touch the LED module.

Glass

1. Thread two headless screws (H) through the mounting plate (A), then secure them with

four lock nuts (D) ( two on each side of the mounting plate (A) ). Adjust the length of the

headless screws (H) if necessary ).

Note: Make sure that the headless screws (H) are lined up horizontally, to ensure that

the fixture will be level.

2. Attach the mounting plate (A) to the outlet box by using two mounting screws (B).

Turn off the power at fuse or circuit box

Installation Steps

Mounting Plate (A)

Glass Holder (I)

Ball Nut-b (J)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before installation, discharge yourself by touching a grounded bare metal surface to remove this hazard.
PAGE 2
4. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections (E) using the wire connectors (E): ---Connect the black wire from the fixture to the black wire from the power source. ---Connect the white wire from the fixture to the white wire from the power source. ---Attach the fixture grounding wire to the cross bar with the green grounding screw (C). Then connect it to the house grounding wire with a wire connector (E). Carefully put the wires back into the outlet box.