Assembly Instructions

Step 3
Step 4
Stand theTable up.
Place the Table on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
This will help to align all parts at all joints.Then get off the Table, and in a sequential manner,
proceed to tighten all Bolts. When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute this same process.
Note: This step is done best with the assistance of a second adult.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Step3.1:Attach Wooden Countertops(A) to Short Leg(c) using Bolts(①) with Allen Key(④) as
shown above.
Step3.2:Attach Long Leg(B) to Short Leg(c) using Bolts(②)and Washer(③) with Allen
Key(④) as shown above.
Step3.3:Attach Long Leg(B) to Short Leg(c) using Bolts(②)and Washer(③) with Allen
Key(④) as shown above.
Do not fully tighten the Bolts.
B
A
setp3.1
①
④
setp3.2
B
A
C
B
A
B
C
setp3.3
C
③
②
④
③
②
④
Page 4 OF 5