Owner Manual

6
D
E
A
A
ALWAYS unplug this fireplace heater before assembly or cleaning, or before
relocating. Failure to do so could result in electric shock, fire, or personal injury.
E
B
B
B
STEP 4. Align the holes in the wall bracket (E) with the pilot holes and drywall anchors. Thread
wood screws (B) through washers and holes in the wall bracket, then directly into the wall studs
and/or drywall anchors. Make sure bracket is level. Tighten all screws securely with a screwdriver.
STEP 3. Drill a pilot hole into each mark using a 1/4” wood drill bit. A. If screws will go into three
studs, no drywall anchors are needed. B. Tap the drywall anchor(s) (C) carefully into the drywall
holes until they are flush with the drywall surface. Use care to avoid damage.