Installation & Assembly

Installation Guide
ON
Lighting
Tools You May Need
GOGGLES
TAPE MEASURE
RUBBER
GLOVES
PHILLIPS
LADDER
DRILL
SCREW DRIVER
Parts List
A.
B.
C.
D.
E.
A B
C
D
E
Circuit Box
Mounting Bracket x 1
Outlet Screws x 3
Wire Connectors x 3
Ground Screw x 1
Canopy Screws x 2
We highly recommends to use a qualified, licensed electrician to install the
fixture.
LED INFO & WARNINGS
•
•
•
•
Please read and comprehend the entire manual before attempting to
assemble, operate, or install the product.
Make sure that you have all necessary parts by checking the parts list.
All parts must be used as indicated in these instructions. Do not substitute
any parts, leave parts out, or use any parts that are worn or broken.
Inspect the LED fixture prior to installation to make sure that it has not
been damaged during shipping.
Please handle the LED light with care when unpacking. Do not apply
pressure to the LEDʼs, do not open any factory sealed compartments, and
do not touch the LEDs with your hands.
•
•
•
•
•
We recommends ELV (Electric Low Voltage) type dimmers for this
fixture.
Shut “OFF” the electricity at main fuse box.
Place the wall switch in the “OFF” position of the room you are installing
the fixture.
•
•
We
recommends to install the fixture on its own independent circuit. Do
not install the fixture on the same circuit with other appliances, or HVAC
systems.
Do not remove or replace manufactured driver that is provided with the
fixture.
DO NOT CUT WIRES attached to the fixture under any circumstance.
Cutting wires will VOID your warranty. Excess cable should be neatly
looped and tucked into the canopy.
Please remove the canopy from the box prior to the fixture body. Failure
to do so can potentially lead to cables getting tangled.