Installation & Assembly

ManualsBrandsWade Logan ManualsLightingChifdale 1 - Light LED Dimmable Spotlight

Installation Guide

Lighting

Tools You May Need

GOGGLES

TAPE MEASURE

RUBBER

GLOVES

PHILLIPS

LADDER

DRILL

SCREW DRIVER

Circuit Box

We recommends to install the fixture on its own independent circuit. Do

not install the fixture on the same circuit with other appliances, or

HVAC systems.

LED INFO & WARNINGS

•

Please read and comprehend the entire manual before attempting to

assemble, operate, or install the product.

All parts must be used as indicated in these instructions. Do not substitute

any parts, leave parts out, or use any parts that are worn or broken.

Inspect the LED fixture prior to installation to make sure that it has not

been damaged during shipping.

Please handle the LED light with care when unpacking. Do not apply

pressure to the LEDʼs, do not open any factory sealed compartments, and

do not touch the LEDs with your hands.

•

Parts List

D E

Mounting Bracket

Anchor Screws x 3

Outlet Screws x 3

Wire Connectors x 3

Ground Screw x 1

Canopy Screws x 2

Plastic Anchors x 3

•

We recommends ELV (Electric Low Voltage)

type dimmers for this

fixture.

Shut “OFF” the electricity at main fuse box.

Place the wall switch in the “OFF” position of the room you are installing

the fixture.

•

Summary of content (6 pages)

PAGE 1
Installation Guide LED INFO & WARNINGS • Please read and comprehend the entire manual before attempting to assemble, operate, or install the product. All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn or broken. • Inspect the LED fixture prior to installation to make sure that it has not been damaged during shipping. • Please handle the LED light with care when unpacking.
PAGE 2
Fixture Diagram B Plastic Anchor C Anchor Screw F Ground Screw D Outlet Screw A Mounting Bracket Wall E Wire Connector G Canopy Screw
PAGE 3
Step 1. Install Mounting Bracket Outlet Box Wall Raise mounting bracket (A) to the wall. Mark location for the plastic anchors (B). Drill holes for plastic anchors (B). Insert plastic anchors (B) into hole. A Mounting Bracket Wall Plastic Anchor C Anchor Screw Attach mounting bracket (A) to outlet box with outlet screws (D). Screw anchor screws (C) into plastic anchors (B) to secure mounting bracket (A).
PAGE 4
Step 2. Connect Wires Bare Copper (Ground Wire) F Ground Screw Black (Line Wire) White (Neutral Wire) A Mounting Bracket E Wire Connector Wall Supply Wires: Connect Black (Line Wire) from ﬁxture to Black (Hot Wire) from outlet box. Connect White (Neutral Wire) from ﬁxture to White (Neutral Wire) from outlet box. Ground Wires: Connect Bare Copper (Ground Wire) from ﬁxture to Green or Bare Copper (Ground Wire) from outlet box. Twist wires together clockwise and secure with wire connector (E).
PAGE 5
Step 3. Mount Fixture A Mounting Bracket G Canopy Screw Wall Attach ﬁxture to mounting bracket (A). Secure ﬁxture with canopy screws (G). Attach glass shades (H).
PAGE 6
Step 4. Turn Power ON Turn electricity “ON” at main fuse box. Place the recommended ELV type dimmer switch in the “ON” position to test the ﬁxture.