Caution: You must read this before you proceed Loveseat Label Description QTY A Side Panel 2 B Back Support Bar 1 C Seat (Labelled with face and bottom) 1 Description QTY D Bolt:M6*20MM 11 E Allen Key 1 F Seat Cushion 2 G Back Cushion 2 Label Picture Picture
Before Beginning Assembly: Step 1 Take out the silders in the four ends of the Seatboard(C ) using Allen Key(E ). Step 2 Open the carton and place all the parts on a clean, non-marring surface. Insert the Seat(C) into the Side Panel(A), shown as the picture.
Step 3 Attach Seat(C) and Side Panel(A) using Bolt(D) and Allen Key(E). Loosely tighten the Bolts. Step 4 Attach Back Support Bar(B) to Side Panel(A) using Bolt(D) with Allen Key(E). Loosely tighten the Bolt. Step 5 Repeat Step 1 to Step 3 to attach the second Side Panel(A). Loosely tighten the Bolts.
Step 6 Stand up the loveseat frame , check stability and then tighten the bolts. Note DO NOT fully tighten a BOLT in one go and then move on to the next. Rather, In a sequential manner, gradually tighten each Bolt until all bolts are evenly secured. This methodology will ensure maximum evenness once all Bolts are fully tightened. Step 7 Put the Seat Cushions(F) and Back Cushions(G) on the Loveseat. Your Loveseat is ready for use.
Do not put hot items directly on furniture surface Do not clean furniture with harsh cleansers or polish. To obtain the longest lifespan of your outdoor prodcts, minimizing exposure to direct sunlight is recommended. Children should not climb or jump on the furniture. Do not write on furniture without a padded barrier to protect the surface. To obtain the longest lifespan of your outdoor products, avoid extended and lengthy exposure to rain, snow, and direct sunshine.
