Installation & Assembly

Step 4
Step 5
Attach Table Top(A) to Table Base using Bolts(①) and Flat Washer Rings(④) with
Allen Key(⑦).
Tighten all Bolts at all joints.
When tightening the Bolts, tighten sequentially. DO NOT tighten any Bolt fully and then
move on to the next one. This may cause the frame to warp.
If the Table is not stable it could lead to damage to the product.
Adjust the pre-installed Levelers at the end of each Table Leg until the Table is level
with the ground.
Your Dining Table is ready for use.
This Dining Table can only be used on the flat and level surface.
Page 5 OF 6