Assembly Instructions

Step 2
Step 3
Place the Table onto a flat, level surface.
Then EXERT pressure, floorwards onto the Table with both hands.
This pressure will help the Table reach full alignment at all joints.
In a sequential manner, gradually tighten all Bolts at all joints until evenly secured.
Inspect the Table and make sure all parts are adequately connected.
Adjust the Levellers until the Chair is level with the ground.
To adjust the Levellers, get assistance from an adult partner to lift/lean and hold the
Chair while you are working.
Adjust Pre-installed Levellers
height for balance
Page 4 of 6
Place the Table Top(A) facedown as shown above.
Insert the wooden tenons on Table Top (A) to the housing on Leg (B) as shown
above.
Then attach the Legs (B) to Table Top(A) using Bolts(①) with Allen Key(②) as
shown in picture above.
Do not fully tighten the Bolts.