Tools Required for Assembly: ASSEMBLY RATING Phillips Screwdriver The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being Phillips Screwdriver easy and 5 being difficult). For most 11/2"L products,two persons are recommended.
Thank you for your purchase! We hope you wiIl enjoy your new product for many years to come. Our commitment to providing quality products does not simply end when a purchase is made. We stand behind our products and will provide any support needed in order for you to fully enjoy your purchase. Your satisfaction is the greatest recognition we could have.
FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES It is highly recommended that the assembly should be done near the area of its intended location. Make sure you have enough space to move around during the assembly. Position each part correctly and insert screws or bolts into their respective holes by hand tighten or using the proper hand tool.
Unless you are particularly adept at assembling flat-pack/knock-down furniture, we understand building ready-to-assemble furniture can be a frustrating experience for some. To help avoid confusion and to make the assembly process quicker and smoother, we have provided some helpful tips. Before you begin the assembly, please read the following : 1. 2. 3. 4. 5. 6. 7.
Note:Every cam lock bolt must have a cam lock connector in order to fasten the parts together. (1) Align the cam connector with its side opening (or arrow) pointing to the small driIIed hole. Secure the threded end of the cam bolt by using a screwdriver. Tun right (clokwise) to tighten. (3) (2) Insert the cam lock bolt into the pre-drllled hole above the cam connector. Two parts should fit snugly against each other.
(1) (2) (3) (4) (5) (6) (7) 1pc 1pc 1pc 1pc 1pc 1pc 1pc (8) (9) (10) (11) (12) (13) 1pc 1pc 1pc 1pc 1pc 1pc Before you begin,please read"Assembly and Care Advice","Pre-Assembly Introduction"and "Cam Lock Fastener Assembly Instructions".
A B C D E F G H I J K L M N L29 ∅15 ∅22 φ8х25 ∅4x35 ∅4x30 L20 ∅12 φ6х30 φ8х40 ∅5x50 45x18x15 ∅4x16 Glue: For securing please apply to wood dowel first before inserting into panel 15pcs 15pcs 2pcs 2pcs 2pcs 6pcs 4pcs 4pcs 2pcs 5pcs 5pcs 1pc 2pcs 1pc Due to the size and/or weight of this product,it is highly recommended that the assembly should be done near the area of its intended location.Make sure you have enough space to move around during the assembly.
Rail wheel on panel (#6) is facing on this side. Make sure the orientation of panel (#3) is the same as the diagram. 3 Refer to page 5 on how to secure cam locks (#b) onto cam bolts (#A).
Ax9 Page 9 of 14
Page 10of 14
Page 11 of 14
Support Bar line Cabinet Piacement Draw a line the length of support bar. Stud Studs are 2x4 beams in your wall. They are 10-16 inches apart from each other.
Jx5 For extra stability,if you have a drill bit, you can insert enclosed threading into the studs before the screws. Secure panel wall at marks Securetopanel onto wall.made. Note the slant. 50 Evenly Distributed Hook slant panel on the back of cabinet on top of the slant panel on the wall.
Attach L bracket beneath bottom panel of cabinet and center stud.
